Some new concrete work after the accident. http://cwguy.com/?p=1346
Vacuum cleaning fun
I cleaned out six vacuums today. It was a ton of fun. I hate these baskets, a shovel seems to be much easier to use.
This is William replacing a vacuum motor. Which also looks like fun.
Motor starter problem
I guess I need to replace this motor starter? The last time it happened was five to six weeks ago. http://cwguy.com/?p=1261
Also, my question for today is: Why does everyone always claim to loose $5.00 when something it broken? It sure looked like $1.50 but that is just me. Also, at Hueytown were it is $4.00 for 20 minutes, they still claim they put in $5.00.
Vending machine problem again
This conlux bill acceptor seems to cause lots of trouble. The bill looked fine this time but the stacker looks like it had a problem.
Camera problem again
I figured out the problem has to be related with the power cable run? I can not plug the power line into the power box (either one) because it will blow a fuse. If I use a 12v wall wart power supply, magic. I am using my psx to fine tune the adjustments.
Replaced broken camera
I replaced one camera today. Also, figured out a power problem for another camera.
Also, I figured out the new cameras I purchased will not fit in the old housings. So I need to order two new housings, then all the housings will be the same size.
Tire cleaner hose problem
The hose has a little problem.
This is the device I used to cut the hose. I wonder if I need a tetanus shot after I use this device? I remember the good old days when it was shiny and new. I had to walk to the store uphill from my car.
Broken security camera – update
This is the license plate cam and it is a 1/3" cs mount camera, with a 5 – 50mm lense. The lense is adjusted at the 50mm range. I did not have all my testing exuipment (extention cord, power suply and my psx) but I will try again tomorrow. I believe it is a power line problem. It keeps blowing fuses (AGC-1BC) and I tried both power supplies.
Solenoid problem
Air was coming out of the high pressure gun. This means that a low pressure solenoid is clogged up. I like my new air solenoid setup because you can turn off individual selections to figure out the problem. Then go directly to the correct solenoid bank.
I removed the magnet, then the plunger piece, then cleaned out everything.
This is a close up of the plunger thing.
I cleaned out the base, but it seemed clean. Everything worked fine after putting everything back together.
Water Wizard problem
Problem with the tire cleaner high pressure pass (left). Also, problem with some high and low pressure nozzles being clogged.