I used my circular saw instead of my grinder this time. Looks alot better and was alot easier. http://cwguy.com/?p=1659
Cutting high pressure hose
I was discussing cutting high pressure hose over at autocarwash. Actually, I just posed a question, but I got lots of answers. But, I liked Fred Lenze idea the best. Well he said use a circular saw and I thought about using my crappy Ryobi 18v instead of purchasing a new grinder to replace my Chicago 4 1/2″. I purchased a 5″ cut-off blade and installed the blade.
The circular saw seems to do a good job. Now, I have a battery powered grinder just like the $229 DeWalt?
Mep1, was correct about having the incorrect blade on my grinder. But, I lost my magic piece to get the blade off. I guess, I need to purchase another one if the circular saw does not work. So I might be out $14.99.
Time to cut the lawn
Well, I needed to cut the lawn about a week or two ago. But I used my new Homelite electric mover to cut it. I had to use the electric mover because my John Deere did not work when I tried to start it. It starts then immediately stalls out.
I ran over the extension cord also which is great. Like my fix-it job? I did not have any tape.
High pressure gun problems
I replaced a plastic wand piece and another wand was leaking.
Roof-Mounted attic fan – complete?
It has been a little while since I installed the fan (http://cwguy.com/?p=867) I added a switch and there are no bare wires running to the power now.
I need to try and dampen the sound the fan makes because the installer did a crappy job. But now if I need to hear myself think, I can just turn the switch off. I guess I fixed the problem?
RO pumps moved
RO tank over flowed last night. I removed the romax for the float valves today.
I need to install an easy drain for my ro tank. I just need to make the connection.
RO pumps moved
I moved the ro tank today. Now, I need to make an easier drain for my air compressor.
RO Water problem
My float valve stuck and flooded the equipment room. Just hit the valve and it started working correctly, I hope.
Rowe changer problem
Greg made fun of me for just resetting the changer when I get this “CK L COIN DETCTR” error message. So this time I checked things out better and noticed that the light for the 40vdc on the power control center was not on. Could be bad? I guess I should call Suncoast like Greg told me to. Afterwards I just reset the changer.
Water Wizard problem
The Wizard would not profile the back but it profiled the front fine.