Tried to aligning the switch again. It is vary irritating.
Hamilton changer problem
Worked on aligning the switch again. I can not get it to work very long. It is also vary irritating.
Hamilton changer problem
Changed out the hopper switch today. I am having the same problem. It would not work over two bills. Will have to look at it again tomorrow.
Boiler problem
Greg, also told me what I needed for my boiler problem. A McDonnell & Miller flow switch. Model #: FS4-3
Hamilton changer problem update
Changer must have crapped out when I was sick. Greg came by today and told me what he thought the problem was, the hopper switch. I called my Dad and he has an extra. I will have to try this tomorrow.
Rogers septic tank guy
My Dad went to the washes for me today. I was feeling very bad. He also handled the Rogers septic tank people. Which is good because I would have had to rescheduled.
Holding tank project
I want to convert a Water Wizard Hyper-Concentrate tank into a dilution holding tank. This would give me seven chemical tanks in the same place as three now.
5 gallon chemical containers are about 15 inches tall. This chemical container is about 19 1/2 inches tall. Sizes of the Water Wizard Hyper-Concentrate tank:
It is 60" long 5 feet. 
The fixed lip in the back it 9" long. 
The width on the tank is 24" long 2 feet. 
The height of the opening under the tank is 17 1/2". 
The height of the tank is 31 1/2". 
The width of the unit from the inside of the legs is 57 1/2"".
An additional plan it to replace my other holding tank. This means that I need to remove the perviously install pvc pipes.
Coleman uses Parker 5/8" 300 psi hose to deliver water from the holding tank.
The large tank conpartment is 15 1/2" left to right and 11 1/4 top to middle and 12" high. From top to bottom is 24".
Random item
An easter basket. Seems very random to have in your car to throw on the ground.
Running hose to one bay
The plan was to run hose to the far right bay. I am replacing all the old screw-on fittings with push-in fittings in the process. 
I am running five colors twice for air and chemical. The extra two hoses are for expansion later. In the process I was attaching the foam brush hose and could not get the push connector to let go of the hose so I replaced the fitting. 
While replacing the fitting I must have touched the fitting below it and it started to leak. Then repeat the process for the third in the chain. I decided that every fitting really needs to be replaced apparently. 
I also had problems with the foamer. When I attached the new hoses both fitting started to leak. So I replaced the fittings and everything worked. 
I ran the foam brush hose on the other side and it is not secured with a tie strap any more. 
I removed the old hose and every seems to work great. 
Tire cleaner hose problem
The first problem was the bent deformed presoak hose. Then I could not even tell where the break was on the tire cleaner hose. So I had to turn it on. Then I saw the problem.