Fragramatics Vacuum problem

2617609366_49ec10ed2d[1].jpg2616786061_131ded41d3[1].jpg2616787843_2c2a88355e[1].jpg

I hate working on these Fragramatics vacuums.  The vacuums have 6 special screws to unlock the top and everything is just so crammed in there.  One of the vacuum motors was not working so I had to remove the motor to check the brushes.  The brushes were fine but a fuse was blown.  I will check the fuse first next time.  Even though 2 out of the 3 motors worked, you can still tell there is a problem.

One Reply to “Fragramatics Vacuum problem”

  1. Clean out that muck!! That motor brush dust is conductive, and will fry your motors and, well, anything else it can!

    Kill ALL power sources to the vac, put on a dust mask, grab a blowgun from your air compressor, and use a stiff brush to dislodge crap. It’ll be messy, but worth it.

    Just for the record, I’ve never used a *working* Fragramatics here in Miami. They’re always either anemic, or they just go *click*… and do not suck. Or rather, I guess this would mean they do suck, but not in the right way.

Leave a Reply

Your email address will not be published.