The hose has a little problem.
This is the device I used to cut the hose. I wonder if I need a tetanus shot after I use this device? I remember the good old days when it was shiny and new. I had to walk to the store uphill from my car.
Car Wash Blog / Self Serve Industry Blog and Forum
This is the license plate cam and it is a 1/3" cs mount camera, with a 5 – 50mm lense. The lense is adjusted at the 50mm range. I did not have all my testing exuipment (extention cord, power suply and my psx) but I will try again tomorrow. I believe it is a power line problem. It keeps blowing fuses (AGC-1BC) and I tried both power supplies.
Air was coming out of the high pressure gun. This means that a low pressure solenoid is clogged up. I like my new air solenoid setup because you can turn off individual selections to figure out the problem. Then go directly to the correct solenoid bank.
I removed the magnet, then the plunger piece, then cleaned out everything.
This is a close up of the plunger thing.
I cleaned out the base, but it seemed clean. Everything worked fine after putting everything back together.
I just dumped all the garbage on the lot. Then these people pull up. They filled up an entire garbage can then dumped a large bag of trash in the dumpster. This is the guy that always shows up as soon as you leave.
Note the trophy (right picture), I always drive around with a trophy in my car don't you? Oh and a bear?