Broken Air Compressor?

IMG_0830.JPGIMG_0836.JPGIMG_0840.JPGIMG_0841.JPGIMG_0843.JPG

I finally decided to figure out what was wrong with my air compressor pump.  The wheel would just spin freely and not do anything else.  When I removed the top the pistons? wouldn’t move when I pushed on them.  I would guess that is not good!  It was also dry and gummy.  But who knows what it is suppose to look like?

IMG_0846.JPG

I removed the wheel thing (technical term) I guess this piece is fine?  But I believe I spotted the problem.

IMG_0853.JPGIMG_0857.JPGIMG_0867.JPGIMG_0864.JPG

Looks like something broke in the compressor pump?  🙂  Looks like maybe the pistons seized up and the wheel thing ripped all the crap apart!  But it looks like I have all the pieces and I can easily fix this with some glue!

IMG_0869.JPGIMG_0871.JPGIMG_0873.JPGIMG_0875.JPG

I forgot to tell you the way to get this pump apart is to take all the screws out them hit it with a rubber mallet.  At least it worked for me.  The 2nd picture looks like the piston actually broke/cracked then the whole pump blew up?  Maybe?

IMG_0885.JPGIMG_0883.JPG

But I really can’t decide if the pump just didn’t have enough oil?  Maybe that caused all the problem?  I checked with the dip stick and it didn’t register, that is bad.  So the bottom line is I figured out what the problem was with my Dad’s broken air compressor and with a little glue I will be able to get this old green SpeedAire back as good as new!

Hamilton credit card acceptor problem – Update

IMG_9743.JPGIMG_9732.JPGIMG_9735.JPGIMG_9738.JPGIMG_9740.JPG

To get the Hamilton credit card acceptor out of the unit there are 4 bolts that hold it into the acw-5.  Unbolt them and the credit card acceptor comes right out.  Then remove 2 screws and the acceptor comes off the holder.  I then mounted the new acceptor and reversed the process, tested my credit card and everything worked great!  Now I can accept credit cards with my acw-5.

Vending machine makeover

Picture 549.jpgPicture 548.jpgPicture 547.jpgPicture 567.jpg

I purchased a piece of Optix Acrylic Sheet .220 18 x 24 to replace my yellowing other piece, which cost around $22.  You have to unscrew about 15 screws on my Dilling & Harris Max-Vend II vending machine to remove the old sheet.  I used my Craftsman table saw that I fixed the other day to cut the sheet.  I purchased a little too thick of a piece so .220 will fit but smaller would have been more like the original sheet.  Also the measurements are 16 5/16 x .   Now it looks great.