Rowe changer problems

I got two different errors today.  "L HOPPER EMPTY" which it was not and I am not sure what the problem was I checked the hopper and reset.  The second error was "EXTRA COIN-L HOP" just reset.

Hydrominder problem

Tire cleaner was running out the front of the equipment room.  Which is always great.  The hydrominder does not seem to bind or stick when I am there.  But I cleaned the out side of the valve on the hydrominder.  I hope it works.

Vacuum motor problem

I ripped out one of the wires when I was changing out the brushes.  So I replaced the motor then I droped the old motor on the ground.  Then, I threw the old motor in the trash.

Vacuum motor problem?

The vacuum was not working correctly and I assumed that the motor needed to be replaced.  But it was still working and sparking.  It this okay or does this need to be replaced?  I have no clue so I am still using it.

There was a clog inside the vacuum.  I had to pull the hose out and clean it out.  This has never happened to me before.  I cleaned the vacuum out the other day and it was only half full so it was surprised.

Sandpiper pump fitting swap

I wanted to replace the old fitting with barbs.

I tightened the barb to much and the top piece cracked.

I replaced the fitting with one the went over the crack and it seemed fine.  I will need to check it tomorrow.

Weep works kinda

  

I tested out my weep system today and all the bays worked except one.  I will need to figure out the problem.  Probably the check valve but I do not have a replacement.

Rowe changer problem

I had the same error message "CK L COIN DETCTR" today.  I took the coin assembly out and cleaned and dumped the money out of it.

After that I tested and had a coin jam.  I dumped it again and then everything was fine.