Category: Repair

I replaced the hose for sandpiper pump today.  I did this because I was having problems using low pressure hose at Hueytown.  The pressure is not as high though.

One of my sandpiper pumps lost its prime.  The pump was constantly pumping and nothing would come out.  I had to remove the outlet hose and it primed up again.  Also, the air compressor must have been running allot because it was super hot.

I installed the correct hydrominder discharge hose today.  I have been using just a hose and never had a problem until I had a foot valve suction problem the other day.  So I cut a hole in all my hoses.  Ever sense then I have had a problem with my chemicals being to weak.  It was driving me crazy so when William replaced a hydrominder I noticed the plastic piece in the hose.  I ask Greg and William and they both thought that was my problem.  I installed the hydrominder discharge hose and went down two tips to orange.  I will have to see what happens.

I also lowered the chain today.

Another professional flojet install.  This install was over a chemical bucket so you can reuse the chemical and not waste it.  I could not put it in the holding tank like I did last time.  http://cwguy.com/?p=622

I replaced the flojet setup today with a sandpiper pump.  It does not leak yet.

I purchased and install a MDL-4 4amp 25V fuse today.  It was fun and easy to install.

I was washing down one of my bays when the water quit working.  The timer was dead and when I checked the power I noticed the fuse blew.  Of cause I did not have a replacement fuse.