Car Wash Blog / Self Serve Industry Blog and Forum
My Dad and I baled out water to figure out which drain was clogged. I was able to easily put a hose ten feet in the drain to the sewer. The drain was still clogged but drained very slowly, so we needed to call in the heavy equipment. William brought the auger by later in the day and removed the clog. Which he believes was about 65 feet in the drain.
I found 8 vacuum claws today that were in nasty water. I dumped the water and replace two claws at Wylam.
Seems like moving the valve fixed the problem. It seems misaligned, but it works and does not flood the equipment room.
I can not believe this happened. I would have made this difficult repair, but I have no light bulbs.
It must have been the worse luck, about two or three weeks ago. There was a car accident and then the garbage man put the dumpster on the car bumper and crap. Today, the garbage man moved the dumpster and I got to throw the crap away. Yea
Also, I found a brick "Grave Chemical B'Ham, AL". It is worst lots of money.
I think I finally fixed my float valve problem? I turned the float valve, maybe this will fix the binding problem. I should have tried this before.
The left acceptor needed to be reset. The right acceptor works fine, but the bills get caught and do not get pulled correctly. You insert your bill, the motor kicks on to pull the bill, and it will not pull the bill. You have to move the bill around after the motor starts up. I cleaned the acceptor and it still was messed up.
I am not sure if you can tell but the float is under water. Also, it is still draining out of the tank. I do not understand what the problem is, the float is new. But I messed around with the stem and maybe it is binding at the henge. When I moved the stem to the left it seemed to pop in to place? It started to work fine, but who knows.
The changer had a coin jam. I have never seen a jam like this before.
One controller needed to be reset. Then ever thing worked fine again.