Unloader problem? – Update

IMG_3227.JPGIMG_3228.JPGIMG_3230.JPGIMG_3237.JPGIMG_3244.JPG

Took off the tip off and the weep started working.  Then I tightened the unloader and the pressure started building up.

IMG_3245.JPGIMG_3248.JPG

I think I need to replace the unloader but am not sure how to remove it.  The second picture is what is connected from below.

IMG_3222.JPGIMG_3255.JPG

I was thinking of changing the setup like this.

Unloader problem?

IMG_3048.JPGIMG_3052.JPGIMG_3057.JPG

No water was coming out of the high pressure gun, pressure gauge says 1250 psi.  I am getting water out of the pump.

IMG_3054.JPGIMG_3062.JPG

I believe the unloader (left picture) is not allowing high pressure to pass through.  But the weep is not working either (right picture) and the weep is teed after the unloader.

IMG_3064.JPG

Note:  My high pressure weep does have a solenoid on the outlet to stop the flow when low pressure is in use.  Which it cool, I did not test it though.

Swapped motor starters, finally

IMG_3022.JPGIMG_3026.JPG

Worked the first time.  Wow, that deserves two thumbs up.  But I needed to take a picture, so just one thumb up.

IMG_3038.JPGIMG_3041.JPG

Not sure what the "set relay at full load motor current" needed to be set at, so I left it the same.  The left motor starter is the old one, right the new used one.