I forgot to check the security video but the threads somehow broke off in the foam brush head. I also do not have my easy out with me to remove the threads.
Rowe changer problem
Error message was CK TRANSPORT VF. Bill jammed in the bill acceptor (picture looking down on the bill acceptor).
Sensorton penny problem
Pennies instead of quarters? That is always bad. I did not have a spare Sensortron and adjusting the selectivity controller did not help. I just swapped it out with a vacuum. I also switched the coin acceptors the lazy man’s way by pulling the wire harness out.
Hamilton Changer problem
Someone broke the plastic guard in front of the bill acceptor. They left the plastic piece on the yellow post. I need to purchase a new one.
Attempted meter door and Rowe changer break in – Update
I finished the mortar install and installed some silicone in the gaps between the changers. I noticed today that the coin cup is also broken.
Fix extension cords
I fixed both of my broken extension cords today. I used a new clamp-on type so I can not pull the fitting off like last time. It also looks very professional in the chain saw plug. Cool.
Rowe changer problem
Error message was CK TRANSPORT VF. Bill jammed in the bill acceptor (picture looking down on the bill acceptor).
Attempted meter door and Rowe changer break in – Update
The first picture is after it dried from yesterday. I think it will work well. The next pictures show the finished product? I am going to silicone the gap between the two changers.
Attempted meter door and Rowe changer break in – Update
I had a little friend living under the changer face plate. The face plate is really bent up good.
Not really sure why the changer face plate is so far separated from the bill inlet plate? But I just siliconed the bill inlet to the changer box then everything fit fine.
I think someone also jabbed something in the bill acceptor but it still works.
I also replaced the other changers inlet plate with the Rowe High Security Bill Acceptor Inlet Plate for the BC-1400.
The problem I have now is the changer face plate is bent way off the wall. So my plan is to use Sakrete Mortar/Stucco mix to taper up and even out the gap. Not really sure if this was a good idea? But it looks good.
