One of Wylam's MH wall pack blew out last night. I will have to replace with a 175 watt metal halide bulb.
Another Wylam problem
The last problem I had today was my coin acceptor being jammed. This is an easy fix with a screw driver.
Wylam Rowe changer problems
Today, I saw this awful site from my Rowe changers (BC-200) both did not work. One had this error "CH L COIN DETCTR" which I did not have time to research. Then the other had this message "CK TRANSPORT VF" which was alot easier because of this.
Greg fixed my General Pump problem
Greg fixed my General Pump problem!
Apparently this o-ring was damaged when I crammed the packing into the head of the pump. Now I get 1100 psi. I learned a good lesson today use lots of silicon. Thanks again Greg.
General Pump repair the next day
I started by taking off the head on the pump today. When I took the head off it looked like above. The medal pieces had stuck to the ceramic shaft. After pulling the medal pieces off I put them back into the head. Then I noticed the ceramic shafts had black crap on them. Which I guess is bad? So I put some lube on them and put the head back on.
It still leaks and now the pressure in around 300. Which is bad. So now I do not know what to do.
Also, today I got to dig out two of my bays. YEA!
General Pump repair
I am trying to repair my General Pump T1321 Series 47. It is pulsating enough to close off the bay. I replaced the check valve o-rings about two weeks ago and apparently forgot to replace the top three. The o-rings were damaged pretty good so I guess I need to look at the packing that I replace two days ago. I must have put the packing in incorrectly.
Now the head leaks and the high pressure is still pulsating. Hopefully tomorrow will be a better day for pump repair.