Installed the cpvc today and ran the drain and the water line.
Install the hydrominder and there was a problem. The valve seems to be broken. It is a plastic valve and I did not have any extras.
New equipment idea – J-B Stick Weld
I JB weld the stainless tank again. It seems to not leak any more. That is good enough for me.
All hot water
Today, I made all the water come out of one tank. I thought I did this a long time ago. But it was not working in all the bays. Greg said that the valves defaulted to hot water so I just taped up all the wire ends. This seems to work just fine.
Another really bad Rowe changer problem
The T-handle broke off today. This is just great two broken in less than a month.
New equipment idea – adding water line
Well, actually I just added the tee. I will add the line tomorrow.
Hydrominder problem
The hydrominder would stick and over flow every once and a while. The plan was to replace the spring and the spring looked a little different. Then I noticed the valve. The valve needed to be bent back into shape. This I believe will fix the problem.
Unitec coin jam
I do not understand how this happens. I needed to screw the screw back in.
Hose problem
Busted air line to bay.
Air compressor problem?
The air compressor tank was very hot to the touch. I do not know if that is bad though.
Hydrominder problem
There was another over flow. I will have to look at it tomorrow.