Category: Repair

I finally got a wire through the conduit.  I had to use romex it was stiff enough to get through.

It actually worked after I quit trying to use the same wire that was shorted out.

The air regulator was leaking air and the air in the bay for presoak was sputtering.  So I decided to change out the regulator.

I had to grind off the screw to get the block off.  Then I decided to change out the metering.

The new air regulator which was used would not turn the psi lower then 80.  Then I gave up and decided I needed a new regulator.  I then noticed that the air and the chemical are in a tee together with no check valve.  So I had to cap the air block.

I had a leak on the solenoid bank and I could not figure out what it was.  The push lock fittings are new and seemed to be leaking when the middle bay was used.  So I replaced the bottom to push lock fittings and everything seems to work fine now.

I figured out my timer problem today.  I ran a wire out to the bay to confirm the problem with one of the wires shorting out.  Now, I just need to get a wire down the conduit.  Which I could not do today.  I will need to get a finer wire tomorrow.

Well, I really do not know if it is a problem but it looked bad.  I just replaced the brush and everything seemed okay.

I broke off a key in my dead bolt today.  Luckily my Dad was in town or it could have been worse.