I assumed that the brushes were bad and exchanged them out. Then when that did not work I checked the nozzle. It was the nozzle. Then the coin acceptor would not accept coins. I had to adjust the sensitivity.
Max-Vend II light problems
I can not seem to get the light to work on the vendor. The light will fully illuminate then turn off or light only half way.
RO Reject water project – Siphon breaker
Siphon breaker by drilling a 3/8" hole in the hose. Now it takes 10 seconds when turned on and 8 seconds to turn off. Very slow.
Unloader hose problem
I came to the wash today and water was running out the font door. Which is never good. I installed a hose clamp.
RO Reject water project
Well, I made it all the way around the equipment room. Now, I need to decide how it is going into the holding tank. I also tested the pvc out today. It did not leak which is good. It did create a siphon which wanted to drain the tank which is bad. I think I am going to drill a hole in the hose that connects the sump pump to the pvc. Greg, also thought it was a good idea.
.jpg)
Hamilton changer bill problem
I guess I really do not have a problem, it does not accept the new tens. But my Dad has a problem one of his Mars bill acceptors does.
Broken foam brush hose
I really need to replace all my hoses.
Wax solenoid broken
Wax solenoid is broken. I need to replace it.
Wheel barrel setup
The wheel barrel is always in the way. Why not put it on the wall.
RO Reject water project
I installed pvc and 1" hose today. For my RO reject water reclaim project thing.
A pump will be used because the ro reject tank could not gravity feed the holding tank. The float switches on when the holding tank is low then it provides power to the solenoid and the pump. This is through the "Magic" box. The magic part I do not know how to implement yet.