I wanted to replace the old fitting with barbs.
I tightened the barb to much and the top piece cracked.
I replaced the fitting with one the went over the crack and it seemed fine. I will need to check it tomorrow.
High pressure soap
Changed out the tip for the hydrominder from a beige tip to green tip. It seems to drink to much chemical.
Air regulator fixed
I installed a new used air regulator today. This regulator works and now the presoak it working great. No pulsating air and no leaky regulator.
Weep works kinda
I tested out my weep system today and all the bays worked except one. I will need to figure out the problem. Probably the check valve but I do not have a replacement.
Vacuum cleanout
Cleaned out the vacuums today.
Rowe changer problem
I had the same error message "CK L COIN DETCTR" today. I took the coin assembly out and cleaned and dumped the money out of it.
After that I tested and had a coin jam. I dumped it again and then everything was fine.
Timer problem resolved
I finally got a wire through the conduit. I had to use romex it was stiff enough to get through.
It actually worked after I quit trying to use the same wire that was shorted out.
Valleydale automatic replacement
Greg, sold the Vectors and is putting in Water Wizards 2.0.
The Vectors are officially gone.
Air regulator problem
The air regulator was leaking air and the air in the bay for presoak was sputtering. So I decided to change out the regulator.
I had to grind off the screw to get the block off. Then I decided to change out the metering.
The new air regulator which was used would not turn the psi lower then 80. Then I gave up and decided I needed a new regulator. I then noticed that the air and the chemical are in a tee together with no check valve. So I had to cap the air block.
Rowe changer problem
I had an error "CK L COIN DETCTR" today. Just reset Rowe.