Flojet push lock problem – Update

IMG_5639.JPGIMG_5640.JPGIMG_5642.JPGIMG_5644.JPGIMG_5650.JPG

When you see water coming out of the equipment room it is always bad.  The supply line broke and the fitting to the Flojet was leaking.  Now I can figure out what the problem is, only took 3 days.

IMG_5646.JPGIMG_5648.JPG

I got to drain the tanks again.

IMG_5656.JPGIMG_5665.JPGIMG_5666.JPG

So the problem is two check valves are bad.  One check valve in a random bay and the check valve between the solenoid bank and the Flojet pump.  The plan is to replace the check valve before the Flojet and the hose in the bay should burst because of the high pressure water.  Then tomorrow I can replace that bays check valve.  Sounds good?

Leave a Reply

Your email address will not be published. Required fields are marked *