Meter door break-in – Update

IMG_4374.JPGIMG_4375.JPG

If installed correctly, each SuperSleeve should hold 2800 pounds.  I installed two correctly?

IMG_4389.JPGIMG_4405.JPGIMG_4408.JPG

First, I drilled the holes for mounting to the SuperSleeves.  Then I bent the steel to install.  It was bent at an angle so you can close the door easier.

IMG_4412.JPGIMG_4413.JPGIMG_4414.JPGIMG_4415.JPGIMG_4417.JPG

Drilled, grinded then dremeled, in that order, end result last picture.

IMG_4421.JPGIMG_4424.JPGIMG_4428.JPGIMG_4430.JPG

This is where the problem arised.  The lesson is measure three times and drill once?  But, I messured twice and drilled twice, both crappy.  I think I am just going to start over tomorrow.

Leave a Reply

Your email address will not be published. Required fields are marked *