Fuse blew again – update

IMG_9842.JPGIMG_9845.JPG

I tried a new relay and like Greg said it made no difference. One coil wire is going to the timer load the other to the 24 vac coil in. The throw wires goes to the equipment room.

IMG_9872.JPGIMG_9874.JPG

One throw wire goes to the 24 volt power supply (white lower) and the other wire is not used? It makes no sense. I must have checked wrong. I was getting frustrated and tied to look at another bay then broke it. Had to figure out what the problem was then quit. I think I need to just rerun all new wire to the bay.

I forgot to mention that the relay switch goes back and forth making the noise. I believe this means that there is a wire short? Who knows? It also just does this when the throw wires are attached.