Posts

Posted on

Rowe changer problem

I had the same error message "CK L COIN DETCTR" today.  I took the coin assembly out and cleaned and dumped the money out of it.

After that I tested and had a coin jam.  I dumped it again and then everything was fine.

Posted on

Timer problem resolved

I finally got a wire through the conduit.  I had to use romex it was stiff enough to get through.

It actually worked after I quit trying to use the same wire that was shorted out.

Posted on

Air regulator problem

The air regulator was leaking air and the air in the bay for presoak was sputtering.  So I decided to change out the regulator.

I had to grind off the screw to get the block off.  Then I decided to change out the metering.

The new air regulator which was used would not turn the psi lower then 80.  Then I gave up and decided I needed a new regulator.  I then noticed that the air and the chemical are in a tee together with no check valve.  So I had to cap the air block.

Posted on

Solenoid problems

I had a leak on the solenoid bank and I could not figure out what it was.  The push lock fittings are new and seemed to be leaking when the middle bay was used.  So I replaced the bottom to push lock fittings and everything seems to work fine now.

Posted on

Timer problem resolved

I figured out my timer problem today.  I ran a wire out to the bay to confirm the problem with one of the wires shorting out.  Now, I just need to get a wire down the conduit.  Which I could not do today.  I will need to get a finer wire tomorrow.