Valleydale automatic replacement
Someone tried to kill my vacuum last night
Someone shot a gun into my equipment room. They hit a spare vacuum in the room. It dented the stainless steel. That was not very nice. If I knew who did it I would tattle tale to there parents. Wait a minute. Is this a bad sign? I have a security system but I hate it. I would have to relive the past 12 hours to maybe see what happened.
Vacuum motor problem
I ripped out one of the wires when I was changing out the brushes. So I replaced the motor then I droped the old motor on the ground. Then, I threw the old motor in the trash.
Vacuum motor problem?
The vacuum was not working correctly and I assumed that the motor needed to be replaced. But it was still working and sparking. It this okay or does this need to be replaced? I have no clue so I am still using it.
There was a clog inside the vacuum. I had to pull the hose out and clean it out. This has never happened to me before. I cleaned the vacuum out the other day and it was only half full so it was surprised.
Replaced a bay fuse
I replaced a bay fuse that I smashed in the meter door the other day. (Fuse AGC-3 250V)
Sandpiper pump fitting swap
I wanted to replace the old fitting with barbs.
I tightened the barb to much and the top piece cracked.
I replaced the fitting with one the went over the crack and it seemed fine. I will need to check it tomorrow.
High pressure soap
Changed out the tip for the hydrominder from a beige tip to green tip. It seems to drink to much chemical.
Air regulator fixed
I installed a new used air regulator today. This regulator works and now the presoak it working great. No pulsating air and no leaky regulator.
Weep works kinda
I tested out my weep system today and all the bays worked except one. I will need to figure out the problem. Probably the check valve but I do not have a replacement.
Vacuum cleanout
Cleaned out the vacuums today.