I got to clean out one pit in Hueytown and two at Wylam. It was a lot of fun.
Rowe changer problem
I had the same error message "CK L COIN DETCTR" today. Just reset.
RO tank overflow – fixed?
I moved the float down in the tank. It should work fine now.
Full chemical bucket. The only thing I can think of is when the RO tank over flew. It decided to fill up my high pressure soap bucket. So now I have a full bucket again. Yea.
Neon lights problem
Someone broke the neon lights on the corner the wash.
Softener hose problem
I must have pulled the hose out when moving the new ro tank out. The floor had a good amount of water on it from the ro tank overflow and the softener hose problem.
RO tank overflow
The tank overflowed last night. I am going to wait and adjust the float tomorrow when the water goes down. I also dumped a glass of tea in the tank. Woops. I was totally stupid.
Unitec coin jam
Unitec coin acceptor was jammed. I had to loosen all the screws in the coin acceptor to get the coins out.
New equipment idea – move ro tank
I removed my new ro tank and switched back to my old black ro tank. I had to do this to allow the new/used Coleman equipment to fit in the equipment room. It was a lot of trouble considering I moved it to the other side of the equipment room.
Midfield – Bessemer Super Highway
Water Wizard
Roof-Mounted attic fan – Installed
I measured the temperature today to compare tomorrow after the fan has been running. The Weep Mizer which the probe in outside a couple of inches from the roof said 95. Then the thermometer about a foot or two from the roof said it was 88 inside. I just know it was very hot today especially on the roof.
I drilled a hole from the inside of the equipment room. Then I marked my plan of attack.
Here are some of my crappy tools I used to mount the fan. My crappy riveter which I got from Harbor Freight. I had problems using it to rivet. But it could be me because I have not riveted anything sense high school. Also, my Skil saw is crappy or I can not use it correctly either. It dropped three blades into the equipment room. The chuck thing is bad I guess. Also, I broke one blade myself. My cool GMC drill worked flawlessly but it also has chuck problems sometimes. I only buy the best drills. Actually my DeWalt has two dead batteries.
Fan installed and riveted down.
I used Great Stuff because it is great stuff. My plan is to put roof patching material over the gaps and over the great stuff.
I hooked the fan up to the power and everything worked the first time. I think that it will really make a difference. But I will be able to tell tomorrow.
It was funny as soon as I wired the fan to work. I saw a wasp in the equipment room. The fan turned on and the wasp flew directly into the fan and got killed.