Today, I setup the hydrominders in the tanks. Also, I figured out that one of the tank leaks very slowly.
New idea for new equipment
Today, I was working on my new idea for the new equipment. I think I am going to use the spare insert tanks for my new tanks. I will have to run a water line and drainage for each tank.
New idea for new equipment
Today, I had a new idea about my new used Coleman equipment. I was thinking I could consolidate all my equipment on the right side of my building. To the left side of the building. Then move the new equipment in on the right side. Then gradually convert over to the new equipment.
The new equipment is 25" by 153". This would make me have to remove the new holding tanks. The equipment now on the right side sticks out about 35". I measured at one of my Dad’s washes with Coleman equipment and it is 28" off the wall.
Hamilton changer coin jam
I had a coin jam today. Of course it was after I got home. So I had to drive back out.
Super Little Tree
I found a Super Little Tree with "X-tra Strength". Very exciting.
Washed my car at my car wash
Washed my car at my car wash and broke something. I strayed the meter door and it stopped and said "COIN".
Light out
Another light burnt out.
Vacuum problems
Fuse blew on one of the vacuums.
Coin jam in the coin shoot. This is an awful design for the Fragramatics. But, I also do not know how this happens. This time I just had to tap it and all the coins fell out. The vault was not full of coins.
High and low pressure problem is two bays
I had the same problem in two bays today. There was a high and low pressure problem. I was thinking that it had to be related but the equipment was not in the some equipment cabinet. Both of the bay timers were working correctly and stealing money.
The first think I did was check both the high pressure motor starters. By pressing the over ride button. They both worked. Then I checked the voltage to the transformer it was receiving the correct voltage. But was not getting voltage from the bays. So I check the first bay and the 
timer plug was slightly out. Plugged it in and it worked fine. The next bay I noticed the 
fuse was broken. This fixed the low pressure and I looked at the motor starter again and hit a little blue button to reset it then everything worked okay.
Vandalized with permanent marker
They did I good job with vandalizing with the marker. But gas and some scrubbing got it off.
