Foam brush solenoid problem

IMG_0275.JPGIMG_0279.JPG

When you turn off the foam brush and the chemical still comes out, that is bad.  It also says there is crap in the solenoid valve.

IMG_0280.JPGIMG_0281.JPGIMG_0282.JPGIMG_0284.JPG

You want to check the plunger, usually their will be crap making it be stuck open.  So you have to take the valve apart.

IMG_0288.JPGIMG_0294.JPG

This is about as bad as I have seen.  But usually the crap is smaller.

IMG_0292.JPGIMG_0299.JPG

Sometimes the rubber plunger thing (last picture) can be messed up to allow a constant stream.

I spotted a real UFO!

IMG_0269.JPG

I was listening to my podcast of Coast to Coast AM and spotted this UFO.  Can you believe it?  A real UFO!  Okay, so you doubt the picture?  I will tell you the truth:  there is no way I could have identified this UFO because it is just too far away.  So that is why it is an Unidentified Flying Object!

Dell Inspiron 9300 power button problem

IMG_0265.JPGIMG_0264.JPGIMG_0261.JPG

I got to fix my mother’s laptop!  I had to take off the plastic covering over the power button to get this thing to start.  I guess the button is messed up.  I am planning to replace the plastic piece first then maybe I will try the circuit board if there is still a problem.

Close-Up Freshening Xperience whiteing study

IMG_0204.JPGIMG_0206.JPG

Have you ever wondered what would happen if you smeared Close-Up toothpaste all over your dirty FRP board? I found this toothpaste on the ground and I already brushed my teeth for the week so……

IMG_0209.JPG

This is what it looked like after I applied the “Whitening Cinnamon Blast” to my FRP board.

IMG_0323.JPGIMG_0326.JPGIMG_0330.JPG

I waited 2 days because I wanted super whitening action, not really sure what the white crap comming off the red Close-Up is (first picture).  (Actually, I was sick and forgot to clean it up.)  But I just rinsed the Close-Up off and presto! spotty white FRP!  Worked really well; maybe if you let the Close-Up stay on only 1 day?  The conclusion of this study is if you leave Close-Up on your teeth or anything else it should whiten anything up!