Category: Information

 

I checked out fans at Home-Depot today.  They have three GAF Master Flow fans: pr1 1000 cfpm, 1600 sq. ft., $49.95, pr2 1250 cfpm, 2400 sq. ft., $67.95, pr3 1600 cfpm, 3200 sg. ft., $89.95

I also looked at white elastomeric roof coatings.  Kool Seal #63-300 Energy saving up to 35%, reflects 90%+ $12.79.  I think that the Kool seal sound like a good idea.  I would need 3 or 4 gallons just for above the equipment room.

I am reinstalling the old ro tank and needed to run 1 x 1" line and 2 x 3/4" lines.  I attached the 1" line today.  Also, organized the reject water lines.

Roof-mounted attic fan at the car wash?  The smaller unit is for 1650 sq. ft. and 1170 cfm for $53.82 and the larger is 2100 sq. ft. and 1500 cfm is $110.

Today, it was 98 outside according to my weep mizer and a thermometer about two or three feet from the roof says it was about 95 inside.

There is already a hole in the roof for the boiler and the fan needs a 14 1/2" hole cut.  Would this really help with the heat?

Finished the air manifold today.  Also installed it and hooked up the pumps and tested.  Everything worked great except maybe one of the hydrominders may cause a problem.  The way it is mounted the water line can not be fully opened. 

I pieced together the majority of the air manifold today with the parts I just received.  There will be ball valves and check valves for every air line out.  Is this over kill or just right?

Filled up the ro tank today.  Now I need to run the three hoses.

 This took forever to install.  Even using my .22 caliber power hammer.

My Dad brought my old ro tank back to the wash today.  I will try and fill it up tomorrow.